Page 1 of 1
Setting Offsets for New Shapes?
Posted: Fri Mar 24, 2017 8:27 pm
by Knight Captain
There hasn't been
much discussion about setting offset for new shapes and sprites. How can I set these correctly?
Re: Setting Offsets for New Shapes?
Posted: Sat Mar 25, 2017 11:22 am
by agentorangeguy
I've had some success with just trial and error, changing the Origin (x, y) settings as needed until I found the right setting.
Re: Setting Offsets for New Shapes?
Posted: Sat Mar 25, 2017 4:59 pm
by Knight Captain
With that being the lower right corner to offset from?
Re: Setting Offsets for New Shapes?
Posted: Sun Mar 26, 2017 10:39 am
by agentorangeguy
I think so, and adjusting the x, y as needed with trial and error you should be able to find the right setting